Cervis TM70 Instalační manuál stáhnout pdf (Strana 62)

TM70Bi V3.1 (03/09) 1121174.pdf

IKUSI reserves the right to change this information without prior notice.

ANALOGUE OUTPUT

The analogue output is connected through RL2 connector with the following signals (Imax=15mA):

Name

Function

VOUT

Analogue Output

GND

Potentiometer’s middle point

-V

Negative power supply (Minimun: -50V)

Positive power supply (Maximun: 50V)

TELE-TEACHING (V3.1 OF SOFTWARE OR HIGHER VERSIONS)

Through Tele-Alignment can set the maximum and minimum values, the polarity inversion, acceleration or

deceleration ramp and curve type of the analogue output. To change to Tele-Alignment mode is necessary to

introduce a bridge in the jumper P5 (see Jumpers configuration). Only available for TM70 consol box from

3.1 software version or higher.

CANL

CANH

+VI GND

CAN

ADDRESS

TELEALIGNMENT

Relay outputs

Analogue output

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 75 76

Žádné komentáře

Cervis TM70 Instalační manuál Strana 62