Cervis TM70 Instalační manuál stáhnout pdf (Strana 11)

TM70Bi V3.1 (03/09) 1121174.pdf

IKUSI reserves the right to change this information without prior notice.

Connect the power supply and the receiver outputs on the corresponding relay board plug-in

terminals. Do this following the outputs diagram, which is supplied with the set. This diagram

indicates the correspondence between the transmitter commands and the receiver outputs.

The STOP relays KSTOP1 and KSTOP2 are in series and must be connected to the main

contactor coil circuit.

The K2/START is activated once the start-up command is held down.

The K1/SAFETY relay is a safety relay, which is activated when certain commands predefined as

“active” on configuration of the set, (i.e. commands which give rise to manoeuvres), are activated.

Figure 4. Receiver’s electronic card

Remember to connect the ground cable.

Only use fireproof cables for connections.

Select the appropriate voltage on the receiver, (230, 115 or 48 Vac – 12 OR 14 Vdc)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Žádné komentáře

Cervis TM70 Instalační manuál Strana 11