Cervis TM70 Instalační manuál

TM70Bi.v1.1.doc (10/03) Cervis reserves the right to modify this information without prior notification. OPERATION & INSTAL

TM70Bi.v1.1.doc (10/03) 9 DATA: When ON indicates that the data received has a correct format. ID: When ON indicates that the receiver has rec

TM70Bi.v1.1.doc (10/03) 10 5.- USING THE SYSTEM To ensure correct use of the equipment, follow the instructions below:  Make sure the transmitt

TM70Bi.v1.1.doc (10/03) 11 Cervis Inc. guarantees the TM70 remote control systems for a period of up to two years after the date o

TM70Bi.v1.1.doc (10/03) 12 Solid green Transmitter transmitting normally. OPERATION mode. Green pulses. Transmitter ready for start-up. STAND BY

TM70Bi.v1.1.doc (10/03) 13 If the failure is determined to be associated with the system, please contact Cervis Inc. at (724) 452-3775 and obtain

TM70Bi.v1.1.doc (10/03) 14 ANNEX A - PROGRAMMING A SPARE TRANSMITTER. For damaged transmitters it is possible to quickly restore service with

TM70Bi.v1.1.doc (10/03) 15 ANNEX B.- PROGRAMMING THE MACHINE IDENTIFICATION IN LCD TRANSMITTERS. Transmitters with the LCD display option

TM70Bi.v1.1.doc (10/03) i I N DEX PAGE. 1. INTRODUCTION ...

TM70Bi.v1.1.doc (10/03) 2 1.- INTRODUCTION Congratulations, you have purchased one of the safest most reliable radio contols availab

TM70Bi.v1.1.doc (10/03) 3 2.- SYSTEM DESCRIPTION The TM70/1 and TM70/2 push-button style transmitters are designed for the remote control of hois

TM70Bi.v1.1.doc (10/03) 4 3.- SAFETY INSTRUCTIONS These instructions must be read carefully in order to install and use the system

TM70Bi.v1.1.doc (10/03) 5 4.- INSTALLATION 4.1.- THE CB60 BATTERY CHARGER The battery charger, CB60, has two charging compartments tha

TM70Bi.v1.1.doc (10/03) 6 4.2.- RECEIVER Make sure the machine is stopped for the entire duration of the installation process. Keep

TM70Bi.v1.1.doc (10/03) 7 The STOP relays K15 and K16 are in series and must be connected to the main contactor coil circuit. The

TM70Bi.v1.1.doc (10/03) 8 Once the receiver has been connected, disconnect the power supply to the motors, (for example, by removing the fuses) a